Bultaco Pursang 250 MK5 (Model 86) with MK6 (Model 103) engine and fuel tank. Also has Husqvarna rear wheel (fitted by previous owner) and front forks have Montessa stamp on them. Rear rim has been powder coated by a previous owner.
I bought this bike as "ready to race" about 5 years ago. But found the following was required:Fibreglass fuel tank sides were soft so bought a second hand MK6 tank to replace.Required rebore so new piston and rings fitted.Wrong electrex world ignition kit fitted so had to buy and fit the right one.Frame powder coated.New side panels and fenders fitted (two sets of fenders plastic and repro fibreglass-see photos)New Renthal handlebars.Kill switch fitted.Wide footpegs fitted.Removed Bing carb and replaced with brand new pre jetted Mikuni 36mm carb fitted from In Motion.New carb manifold and airbox rubber fitted with new carb.New front brake and clutch cables.New Betor 340mm shocks fitted (not the best, but i think shocks are a personal choice so didn't want to spend alot of money on shocks as decided to sell).after owning the bike for a year i bought another bike to race and have bit by bit done the work above. I now race in other categories and have no use for the bike. Finally have it running right as new Mikuni carb was the last job done. Please email any questions. I have lots of detailed photos, but ebay listing only allows 12. Viewings welcome - i am available on weekends and my retired father available weekdays.